Hydraulic Shearing machines

Request a Quote

"SANTEC' presents to you a range of most technically advanced hydraulic shearing machines with all latest features as per international standards.

Salient Features:

1. The stable robust, all welded steel frame from ultra sonically tested plates are of top quality. Raw & table designed with special inclined member & box type struture for maximum strength.
2. The top beam is guided by three point roller with replaceable hardened liners for least wear. This eliminates lubrication of steel to provide better quality of cutting for alonger time.
3. Rake angle can be varied to permit shearing of higher thickness than nominal capacity & facilitating distortion free shearing of thin sheets.
4. The fastest & eagiest way of blade clearance setting without need of feeler gauge, which helps burr-free edges.
5. Positive holding by hydraulic holddowns before shearing avoids slippage of sheets & independent operation of holddowns for clamping of sheet helps checking of mark without taking shear stroke
6. Front gauging by dis appearing stoppers mounted on left squaring arm. Robust, heavy & accurate back gauging to set cutting width.
7. Easiest and fastest clearance setting arrangement with Direct Calibration to thickness.
8.Hydraulic cylinder are designed with both low & high pressure sealing, hard chrome plated rod also with special type guide for long life without leakage.
9. Hydraulic components are of international quality standards & assembled on specially designed compact mambold block for easy maintance.

Standard Accessories:

Main Drive Motor Electric Control Panel Operational Console Pre selector switch to adjust rake angle Lever operated blade clearance with calibration Fine stroke adjustment rod with limit switch Front sheet support Squaring arm on right end with steel rule Hardened transfer bar mounted on table Hold down cylinders Shadow light indicator Four edge HCHCR / HCSR blade Interchangeable & suitable to shear mild and St. Steel Manual back gauge Optional Accessories : Motorised back gauge with DRO NC back gauge with ball screw Second squaring arm on left side Front support with roller according to required length Rear sheet support Ball transfer table Degree protector for angular cutting Stroke counter Design with throat depth First fill of hydraulic oil

Request a Quote